Re: ERL was fast but not is very slow - Centurylink says its my issue
2 hours ago it was fixed now he bricked your router?It was suggested to upgrade to the non-GA firmware as it allowed PPPoE configuration. I did such. The router would not come back online. I rebooted...
View ArticleRe: ERL was fast but not is very slow - Centurylink says its my issue
Nope, still wrong. :-(Can you provide a screenshot of what "right" is?
View ArticleEdgeRouter X compared to consumer routers?
Evening all, I am upgrading my entire home network and am trying to get a new router. My home internet is cable with 80Mb/s down and 20Mb/s up over coaxial. I'm currently viewing the EdgeRouter X / SFP...
View ArticleRe: EdgeRouter X compared to consumer routers?
Properly setup, ER-X can handle almost a gigabit. The key being the properly setup part.
View ArticleRe: firewall match against DSCP (TOS) field
In AD environment, use GPO to set QoS centrally. Creating and Editing a QoS Policy On home PC , use gpedit.msc to do it locally.
View ArticleRe: ER-X VLAN assistance (cross-VLAN pings, guest portal, wired IoT device)
You might give this a shot:Put all ethernet ports on switch0. Create a new WAN VLAN, and set WAN port (eth0) pvid to it.
View ArticleRe: EdgeRouter X compared to consumer routers?
ER-X contains 256 Mb DDR3 RAM, 256 Mb SLC NAND flash and MT7621A SoC (2 core 4 threads) with built-in gigabit switch.It can be almost matched in wired perfomance with Asus N56U B1, Buffalo WSR-1166DD,...
View ArticleRe: EdgeRouter X compared to consumer routers?
,Your 1st link is outdated. The review is from dec 2015 , at that time ER-x hardware acceleration (=offload) wasn't supported yet.
View ArticleRe: Site-to-Site VPN between EdgeRouter Pro 8 and Cisco ASA 5510
Hi , Sorry, I am unsure how to remove from the CLI. I am new to all this. If you can that level of guidance, it would be greatly appreciated. Below is the result of "show load-balance" from the...
View ArticleRe: Site-to-Site VPN between EdgeRouter Pro 8 and Cisco ASA 5510
Per my prior post, here's the second part of my configuration: name WAN_LOCAL { default-action drop...
View ArticleRe: Site-to-Site VPN between EdgeRouter Pro 8 and Cisco ASA 5510
Here is the third part of my config: ethernet eth2 { address 192.168.1.1/24...
View ArticleRe: Site-to-Site VPN between EdgeRouter Pro 8 and Cisco ASA 5510
Here is the fourth part of my config: service { dhcp-server {...
View ArticleRe: Site-to-Site VPN between EdgeRouter Pro 8 and Cisco ASA 5510
Here is the fifth: system { conntrack {...
View ArticleRe: Site-to-Site VPN between EdgeRouter Pro 8 and Cisco ASA 5510
Here is the 6th part of my configuration: vpn { ipsec {...
View ArticleRe: BGP Reconfigure for 1.8 request
Ok so i reapplied the router upgrade this evening. There was an issue with my static routes and they were removed after the upgrade. I attempted to recreate them and got the error: Nexthop address...
View ArticleRe: Help setting up NetFlow
Can you try manageengine netflow analyzer. https://www.manageengine.com/products/netflow/download.html Default listener port is 9996
View ArticleRe: ERL was fast but not is very slow - Centurylink says its my issue
You have your firewall attached to eth1 but your WAN is actually the pppoe under vif 201 so that is where your firewall should be. Right now you have no firewall on your WAN hence your vulnerability to...
View ArticleRe: Site-to-Site VPN between EdgeRouter Pro 8 and Cisco ASA 5510
First try moving up NAT rule 5003 above the other masquerade rules. So it overrules 5000 and 5002. (easy to do in GUI)
View ArticleRe: Edgemax Torrent blocking
Has anyone able to stop downloading the torrent? What i am doing wrong ??? The method posted in this thread is working for a short period of time (see the printscreen of the firewall config and Traffic...
View Article