VPN | connecting to different subnets
Hi, I have an EdgeRouter-Pro with four subnets configured.Now i wanted to configure l2tp/ipsec, so that some windows clients are able to connect to a subnet. This is working so far, but i see no way to...
View ArticleRe: Edgerouter Lite 100% CPU on 130Mbps
Any chance there were some other changes you made along the way via cli that were not saved?
View ArticleRe: Edgerouter Lite 100% CPU on 130Mbps
You're using configurations that are not offloaded as such processing goes through main CPU.SW bridging is not offloaded for sure and I think bonding too (not 100% sure though). Remove the SW bridge,...
View ArticleRe: Edgerouter Lite 100% CPU on 130Mbps
I have a habit to save after each commit and it was a few weeks since I made any configuration changes other then VPN configuration.
View ArticleRe: VRRP Master does not send HELO multicast messages
Hi David, I don't know how to proceed from here in order to get this bug solved?Which way do I have to go? Who do I have to address this problem?Would appreciate your respons as I need to go live with...
View ArticleRe: VRRP Master does not send HELO multicast messages
Lets now page . sending you a pm,
View ArticleRe: VRRP Master does not send HELO multicast messages
Paging ...I've also added link to this to beta forum post here.
View ArticleRe: VRRP Master does not send HELO multicast messages
Have you verified that keepalived is running on the master (ps aux | grep keepalived). One of the things I've noticed is if keepalived is started with a bad parameter it will just quit. Check...
View ArticleRe: How to drop ICMP echo response on WAN port?
Remove the 'all-ping enable' from your config. Change it to: all-ping disable
View ArticleRe: Edgerouter Lite 100% CPU on 130Mbps
But I had the bonding and the SW bridge before the power outage and still got 250Mpbs without major cpu usage.
View ArticleWhy can't I keep a remote access VPN working? L2TP or PPTP, is there a...
So I'm trying to setup my remote access VPN. Both IPSec/L2TP and PPTP work for awhile, then stop accepting new connections, authenticating, anything. Rebooting the firewall corrects the problem...
View ArticleMulti Wan load balancing question
Hi,I know the edgerouter series can be set up to load balance using multiple wan interfaces,However all configurations seem to be load balancing throughput. We have a situation where we have multiple...
View ArticleRe: Multi Wan load balancing question
See: https://github.com/jivetek/EdgeOS-Failover_PBR This is the best case for your configuration.
View ArticleRe: Multi Wan load balancing question
Yes, Policy Based Routing or PBR is what you should be looking...
View ArticleRe: Edgerouter Lite 100% CPU on 130Mbps
With respect, there's no way you got 250Mbps with a software bridge and low CPU usage - it just isn't possible. Software bridging, by definition, requires *every* packet to pass through the CPU,...
View ArticleRe: Edgerouter Lite 100% CPU on 130Mbps
Sorry if I expressed myself badly, the software bridge was just an experiment to get a layer 2 bridge over OpenVPN and I never got close to 250Mbps, got around 12Mbps over the tunnel. The issue...
View ArticleClik here to view.
Re: ER-X unexpected problems trying to assign a fixed management interface
It was a long battle, but I think I finally licked it. The two things that turned the tide for me were:Add a second IP address in 10.24.35.0/24 on my workstation for management (really should have...
View Article