Re: Disabled interfaces enables itself after some time

Hi,

It took a few hours until it falled back to this disEnabled state. I've attached a screeshot and the output as requested:

r00t@Router:~$ show interfaces ethernet eth1
eth1: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc noqueue state UP group default
    link/ether 44:d9:e7:9f:1c:08 brd ff:ff:ff:ff:ff:ff
    inet 192.168.2.100/24 brd 192.168.2.255 scope global eth1
       valid_lft forever preferred_lft forever
    inet6 fe80::46d9:e7ff:fe9f:1c08/64 scope link
       valid_lft forever preferred_lft forever

    RX:  bytes    packets     errors    dropped    overrun      mcast
     122765578     121676          0          0          0         14
    TX:  bytes    packets     errors    dropped    carrier collisions
      33050548     173601          0          0          0          0

seems it has somehow enabled itself

r00t@Router:~$ show interfaces counters
Interface    Rx Packets   Rx Bytes     Tx Packets   Tx Bytes
eth0           50701477 60048356148       12045585 1733995177
eth1             121802  122774862         173849   33077923
eth2                  0          0              0          0
eth3                  8       1922              7        546
eth4                  3        192             12       2256
eth5                  0          0              0          0
eth6           13403922 1971309385       43212766 60960625370
eth7                  0          0              0          0
imq0                  0          0           5419     173408
lo                80264   13995655          80264   13995655

 ...and countig up

 ping only works if i enable nat but if the if should be down it shouldn't matter if the nat rule is enabled or disabled, right?

Thanks in advantage,

-fipse