Re: Bandwidth of Site-to-Site VPN
Sorry for my absence in this thread. I got busy and didn't get a chance to further experiment with this and then took some vacation for the holidays. In any case, upon my return about a week ago, I...
View ArticleClik here to view.
Re: ER-L PPPoE connection problem
Thank you for your help! That could be it!I followed your instruction, with a boot-up reset and reinstall firmware, and delete the old image as well. Deleted the default ubnt user, create a new one...
View ArticleRe: EdgeMax Switch LAG setup with QNAP NAS
A LAG won't necessarily make copying of files any faster. The LAG you've configured gives you 4 x 1Gbps links that can carry traffic, and not a 4Gbps link. Each individual link in the LAG continues to...
View ArticleSpoke to Spoke connection
Hi, I have a "central" site X to which 2 remote sites A and B are connected using IPsec site-to-site tunnels.Both site A and site B can communicate with site X, but not with each other.i.e. traffic...
View ArticleClik here to view.
Setting up an internal LAN to be routed through TOR. (HOWTO)
Hi guys, I made a setup on my Edgerouter where I route all traffic from one lan through the TOR network.My blog entry can be found here: http://www.cron.dk/serving-tor-on-an-internal-lan/ Comments are...
View ArticleRe: Edgerouter pro firewall rules for VRRP
This is what I don't understand there's two rules on both the routers which pretty much say Allow all UDP and TCP and Allow all Protocols. .28 - VRRP Gateway.29 - Router 1.30 - Router 2
View ArticleOpenVPN Site-to-Site & Firewall
Hello everybody, I have a little problem with an OpenVPN Site-to-Site connection and the firewall between 2 EdgeRouters. Maybe somebody here can help me to understand that issue : I have an EdgeRouter...
View ArticleRe: Edgerouter pro firewall rules for VRRP
VRRP isn't UDP or TCP, but protocol 112. (you might try allowinging multicast IP 224.0.0.18)Post your configs. Maybe this isn't a firewall issue but some config mismatch
View ArticleClik here to view.
Re: Google Fiber - Which router should I buy?
Henrik wrote:kvic wrote:That's about right. ER-X won't be able to fully utilize 1000/1000. I explained here: http://kazoo.ga/re-visit-the-switch-in-edgerouter-x/ I believe it's a FW decision for ER-X...
View ArticleClik here to view.
Re: Edgerouter pro firewall rules for VRRP
I've just allowed Protocol: VRRP anywhere anywhere, it works fine now Cheers.
View ArticleRe: Problem with load balancing with PBR
Hi it works for awhile but after that both interface goes inactive. show load-balance watchdog state that they can't ping ubnt.com . Also while it works for awhile it doesn't seem to balance the...
View ArticleRe: Spoke to Spoke connection
Tunnel A-XIn current A<->X config, most likely you're allowing LanA<->LanX. At side A , add tunnel under peer for LanA<->LanB traffic. Do the same at site X. Tunnel B-XRepeat...
View ArticleRe: OpenVPN Site-to-Site & Firewall
The allow in a firewall rule is for a new connection only hit once. subsequent packets will use the established/related rule. So removing the openvpn allow rule won't shut down an already connected...
View ArticleRe: Pixelated VOD IPTV
+1 here. I have just switched from a Mikrotik RB750 to an EdgeRouter POE.I get pixelated VOD when someone is using the VPN from outside
View ArticleRe: Reduced Throughput on ERL3
TheTCat wrote:Thanks. I'll remove the redundant NAT rules and see if that helps.Those few NAT rules wouldn't have any impact. I have an order of magnitude more NAT rules, and an even greater number...
View ArticleRe: Open VPN networking is working but no internet access
set service dns forwarding listen-on vtun0I tried with this line as well, its not working here's my ovpn file:client dev tun proto udp remote xxx.xxx.xxx.xxx 1194 float comp-lzo yes push "comp-lzo...
View ArticleRe: Open VPN networking is working but no internet access
Your DNS resolution is not working. The tunnel is set up fine. You need to make your router listen for DNS forwarding on vtun0. When you say it didn't work, do you mean you got an error when typing the...
View ArticleRe: Will This VPN Setup Work?
Aaarrrgggh wrote:I guess my concern or question is what exactly are you trying to do on the remote sites? Are you managing the network for your clients, or managing PCs for a client, or managing a...
View ArticleRe: Reduced Throughput on ERL3
Sure. Offloading is enabled by default I believe...:~$ show ubnt offload IP offload module : loaded IPv4 forwarding: enabled vlan : disabled pppoe : disabled gre : disabled IPv6 forwarding: disabled...
View Article