To simplify the setup, i have bought a second switch to carry the vlans of the vlans i have to "limit". And then going to force the port to 100 mbps
That raises a question about edgemax setup.
How do a configure eth2 (not in use corrently) to carry vlans (same and different from eth1)?
Current setup:
eth0: WAN
eth1.1,eth1.7, eth1.41, eth1.42, eth1.61,eth1.62
eth2: not in use
Wanted setup:
eth0: WAN
eth1.1,eth1.7
eth2.1, eth2.41, eth2.42, eth2.61,eth2.62
As you can see i want port 1 to carry vlan1 and vlan7, and i want port2 to carry vlan1 aswell, and the other vlans (41,42,61,62)