Hi to All
I have to build a simple office network using one ER-X and three UAPs (one standard AP and two AC Lite's)
Network will be used by three companies, lets name them A,B,C. There will be also Guest network and shared printer.
My concept is to use Eth0 as WAN and Eth1/2/3 for UAPs, Eth4 will not be used but it can be configured for just internet access and management
I run WAN+2LAN2 wizard and then
For Eth1 (UAP AP AC Lite) i configure
VLAN 10 (for company A - SSID A)
VLAN 20 (for company B - SSID B)
VLAN 30 (for company C - SSID C)
VLAN 40 (for Guests - SSID HotSpot)
Eth2 (UAP AP AC Lite)
VLAN 11 (for company A - SSID A)
VLAN 21 (for company B - SSID B)
VLAN 31 (for company C - SSID C)
VLAN 41 (for Guests - SSID HotSpot)
Eth3 (UAP AP)
VLAN 22 (for company B - SSID B)
VLAN 32 (for company C - SSID C)
VLAN 42 (for Guests - SSID HotSpot)
VLAN 50 (for printer - SSID PrinterLink)
Then i set up bridges
Bridge 1 (VLAN 10/11/50)
Bridge 2 (VLAN 20/21/22/50)
Bridge 3 (VLAN 30/31/32/50)
Bridge 4 (VLAN 40/41/42)
Is this concept correct?
Can i use one DHCP or do i have to configure seperate DHCPs for every vlan?
In UAPs i just set up four ssids asigned to vlans or i have to do something more?
What else i have to configure?
I'm new to ubiquiti equipment so i will appreciate any help