Re: Interlan Routing Edgrerouter x
See https://community.ubnt.com/t5/EdgeMAX/Known-Issues-of-EdgeMax-Series/m-p/1805816#U1805816 issue 10
View ArticleRe: Comcast IPv6 issues when hwnat enabled on ER-X
I'm a total newb with this without an in depth understanding of the CLI settings but I followed the inputs from the residential Comcast thread settings and seems to be fine. I am in NH with a Netgear...
View ArticleRe: Comcast IPv6 issues when hwnat enabled on ER-X
I should also note that I'm on v1.9.1 and did do a power off cycle on the ER-X.
View ArticleRe: EdgeRouter Lite 3 port 53 open
That was indeed the root cause. Marked as solution. Thanks. Edit: But now my forwarded ports won't work.
View ArticleRe: Verizon DSL to 162.168.0.0 network
I don't understand a lot of this. What is a 'WAN IP passthrough'? Do you expecta public IP address from your DSL modem? If so,perhaps it can be put in bridge mode, perhaps not.What exactly do the...
View ArticleRe: Edgerouter pro as ntp server
If I understood correctly, edgerouter has configured ntp server?
View ArticleRe: Restoring Config File?
If you load the same configuration file into two differentrouters and they both fail, it appears to be a bad file. Useanother file if you have one, or re--configure the router. Dave
View ArticleRe: Verizon DSL to 162.168.0.0 network
Of course Verizon Tech Support is clueless. You should set the Verizon modem into transparent bridge mode. Most modems support that. Some don't. My FiOS Actiontec modem does. My two CenturyLink DSL...
View ArticleRe: Verizon DSL to 162.168.0.0 network
You make a good point I missed: If you set the ER-X to that huge class-B subnet, itincludes the 192.168.1.n subnet that your modemprovides. It's not possible to route between twosubnets that have...
View ArticleRe: So you want to replace a BT Homehub?
I've gone for a default NAT rule here, and not looked at the Port Forwarding config, but as it's a simplified NAT configuration, with similar flexibility to the Home Hub capabilities, it's probably the...
View ArticleClik here to view.
Problem with ERL3 eth0 dosn't work
Hello, So I just bought some days ago a ERL3, it came quickly at my place, I take some times to understand how it's work, because it's the first time I use a so much powerfull devices in my LAN...
View ArticleSetup Problem with Static IP subnet
Hello, I'm trying to set up the WAN on my EdgeRouter (firmware 1.9.1). I have a /29 from my ISP, and I have ethernet out of the fiber box. Using the simple setup wizard, I assign the WAN to eth0. If I...
View ArticleRe: Verizon DSL to 162.168.0.0 network
I hadn't thought about that. I don't see where the OP said he was using a /16 subnet mask though. Everything should work fine if the Verizon router is using 192.168.0.0/24 and the Edgerouter is using...
View ArticleRe: Verizon DSL to 162.168.0.0 network
I may be making too much out of what is probablya typo: "Static pool 192.168.0.0 - .100" I haven't setup a DSL modem in a long time. But it ispossible to set many carrier DOCSIS modems inbridge...
View ArticleIPv6 Firewall: Outbound
Is there a way to assign a private IP scope and use NAT with IPv6 like we do with IPv4? I want to restrict outbound IPv6 except to approved devices. The complicating factor is that whenever my WAN...
View ArticleClik here to view.
Re: Verizon DSL to 162.168.0.0 network
OP here. The .100 was just me saying that my static pool of address was .0 through .100. My bad. I have never had to "mess" with a DSL modem before moving here. Always had cable and owned my own...
View ArticleRe: Verizon DSL to 162.168.0.0 network
It sounds like the Verizon/Dlink should be set to LAN-WAN bridged Ethernet and the EdgeRouter WAN interface set to PPPoE. -- Pete
View ArticleRe: Problem with ERL3 eth0 dosn't work
Okay, without doing anything, the eth0 port work again....I don't know why...
View ArticleRe: Smart Queue seemingly not working for Steam downloads
I haven't tried the new ingress flag, but my experience with Steam downloads and Cake is pretty much similar to yours. Much of the problem stems from the fact that you're running Cake downstream of...
View Article
