Re: fix Bufferbloat on Edgerouter X (simply)
here are the results of the ping test: Ping statistics for 8.8.8.8:Packets: Sent = 60, Received = 60, Lost = 0 (0% loss),Approximate round trip times in milli-seconds:Minimum = 32ms, Maximum = 41ms,...
View ArticleRe: Enable/Dissable a rule based on an external condition (internet on/off...
After a number of issues with the suggested syntax etc here is what I ended up creating. Please note I am using an EdgeRouter Lite with EdgeMax v1.9.0 1. I created a new "homeassistant" admin user on...
View ArticleRe: Router on a stick not working...Confused..
Cool, glad that was it. Yeah it wasn't even trying to obtain an IP from DHCP, just trying to find its former gateway it looks like.
View ArticleClik here to view.
Re: fix Bufferbloat on Edgerouter X (simply)
Looks ok to me. Could you remove all the Smart QoS (and make sure you don't have anything in Basic Queue or Advanced Queue), then add a new Smart Queue like this: Make sure "WAN interface" is the...
View ArticleRe: fix Bufferbloat on Edgerouter X (simply)
added the smart qos, did ping and test, below are results: Reply from 8.8.8.8: bytes=32 time=35ms TTL=44Reply from 8.8.8.8: bytes=32 time=32ms TTL=44Reply from 8.8.8.8: bytes=32 time=32ms TTL=44Reply...
View ArticleClik here to view.
Re: fix Bufferbloat on Edgerouter X (simply)
ok! neat development, did dslreports test, fail on DL, seemingly low bufferbloat on UL
View ArticleClik here to view.
Re: fix Bufferbloat on Edgerouter X (simply)
Ok, edit your Smart Queue a little so it looks like this: Re-do the test. Does it look acceptable now? If it does, continue by increasing the Download rate little by little until the pings are too high.
View ArticleClik here to view.
Re: fix Bufferbloat on Edgerouter X (simply)
then took next logical step of adding 10 to the Download, re-ran dslreports test: no fails on bufferbloat,... edit: seems I posted at same time as yours,...
View ArticleRe: fix Bufferbloat on Edgerouter X (simply)
Just for testing purposes only, what happens if you set Download rate to 5 Mbps and keep Upload rate at 2 Mbps? Do the ping test again, do you still see those huge spikes? EDIT: If you do, try lowering...
View ArticleRe: fix Bufferbloat on Edgerouter X (simply)
I made changes .25 per change to QoS.In addition to the continuous ping vs. Speedtest, I also monitored dslreports' bufferbloat meter, and backed numbers off when it filled and stayed red.here are the...
View ArticleClik here to view.
Re: fix Bufferbloat on Edgerouter X (simply)
Yeah I'd agree with that. There are things for slower connections that you can tune in the advanced settings but I don't have experience with that, so someone with more knowledge would have to help...
View ArticleRe: Router on a stick not working...Confused..
I've had similar issues with my SmartThings hub. If I swap ports/interfaces, I always have to manually reboot it with the recessed button on the back. Scared the hell out of me that my hub might be...
View ArticleRe: EdgePoint
If I run PoE and connect a 24VDC source to the terminal block I read in the manual that the router chooses the source with the highest voltage for the power source. Is this the case for the Edgepoint 6...
View ArticleRe: ERX + OpenVPN + traffic shaper ?
The link you posted is a good starting point for configuring QoS on your WAN upload link. Either use your fathers public IP as destination, or openvpn destination port (UDP1194) , or both, as a filter...
View ArticleRe: Edgerouter IPSEC VPN two tunnels: to 2nd Edgerouter and to Juniper NS5GT...
On siteB, the remote prefix overlaps your local LAN. This breaks reachability for internal addresses on siteB.I consider this a bug.Workarounds:Use VTI mode tunnelOrManual add route 192.168.2.0/24...
View ArticleRe: Noob Help Please- Rx/Tx Huge Differential ER-X
Do you see these rates on your LAN network too? If so, it's something internal on your network downloading If not, maybe some DoS or portscan is going on . tcpdump on WAN interface shows packets...
View ArticleRe: Noob Help Please- Rx/Tx Huge Differential ER-X
Thanks for your reply. I would presume that if it was something on the internal LAN, then the information would be received (Rx) then transmitted (Tx) to another port? It is only being received Rx, not...
View ArticleRe: Forward WAN to VLAN tagged interface
I know. Is it possible to do it with static routes?
View ArticleClik here to view.
Load balance
Hi all,To the point, I've configured ERPOE 5 - v1.9.0 for this guide, little problem for global name-server google dns, because in my ISP blocking this dns. But so far running well.And now, I want to...
View ArticleRe: Noob Help Please- Rx/Tx Huge Differential ER-X
Turn on dpi (next tab) and see if you can spot a bandwidth hog.
View Article