I removed the port 69 from Source and left 69 in the translation. I'm not 100% sure (without being in front of the phone I am remotely resetting to force to pull the config) but my count is not incrementing and my firewall rule stat is not incrementing, and the tftp log shows no connection activity. (Got with my phone lady and also made sure the extension was set right in the pbxware system, and the phone successfully registers upon being reset.)
So on the surface it seems that it is still not communicating, but I will be at a location with a phone to test a bit later tonight. I'll report back if it pulls the logo or not.
Are there variables that I may not know to articulate to you? Is it really as simple as assigning multiple statics to the wan interface?
We removed an old 100mb sonicwall and replaced with this ERX and this process was working before we swapped so I believe it is doable.
Used wan=2lan2 with eth0 as wan, and checked use only one lan for eth1-4.
Tried to keep the config simple for troubleshooting this. The only other rule is an autofirewall port forward for a high port number to 3389 internal so I can remote back in and make changes.
When I get this tftp working I will lock the source down to a list of static customer ip's but right now it should be wide open.
Again thanks so much for the assistance! I'll be on the road for a bit. Take care.