I apologize on not using proper forum etiquette. Pretty new to communicating through one. I just leverage them on a daily basis by reading them. I was trying to figure out how to start a new topic but it said i didn't have permission. Anyway here is the output you requested.
"show configuration commands | grep eth1"
set interfaces ethernet eth1 description 'FV WT 5.8 BH>RA'
set interfaces ethernet eth1 duplex auto
set interfaces ethernet eth1 poe output 24v
set interfaces ethernet eth1 speed auto
set interfaces switch switch0 switch-port interface eth1 vlan pvid 1
set interfaces switch switch0 switch-port interface eth1 vlan vid 136
set interfaces switch switch0 switch-port interface eth1 vlan vid 447
set interfaces switch switch0 switch-port interface eth1 vlan vid 448
set interfaces switch switch0 switch-port interface eth1 vlan vid 451
set interfaces switch switch0 switch-port interface eth1 vlan vid 501
set interfaces switch switch0 switch-port interface eth1 vlan vid 256
Again because i dont see 254 in that list i wouldn't think the radio should NOT be able to pull 254. Not sure with it being a switch0 vlan interface vs an eth1 vlan interface makes a difference. But i promise i'm well versed in the network realm. I almost feel because its not references here the 802.1q vlan tag just gets forwarded through pvid 1 and device on other side sees it. Guess i could type the "set interfaces switch switch0 switch-port interface eth1" command and see if there is any type of exclude cli command there. Appreciate your help. Again i'm sorry for not using proper etiquette.
James