Took me a while to get it ... but I finally have a serial cable and all. But sadly that's pretty uneventful
This is the output:
INIT: Switching to runlevel: 6
INIT: Sending processes the TERM signal
Stopping DHCP server daemon...
Stopping network plug daemon: netplugd.
[ ok ] Stopping routing services...imi...done.
[ ok ] Removing all routes.
[ ok ] Stopping DNS forwarder and DHCP server: dnsmasq.
[ ok ] Stopping EdgeOS router: rl-system.
[ ok ] Asking all remaining processes to terminate...done.
[ ok ] All processes ended within 3 seconds...done.
[ ok ] Stopping enhanced syslogd: rsyslogd.
[ ok ] Mounting root read-only...done.
[ ok ] Mounting root dev read-only...done.
[info] Will now restart.
reboot: Restarting system
Looking for valid bootloader image....
Jumping to start of image at address 0xbfc80000
U-Boot 1.1.1 (UBNT Build ID: 4670715-gbd7e2d7) (Build time: May 27 2014 - 11:16:22)
BIST check passed.
UBNT_E100 r1:2, r2:18, f:4/71, serial #: 788A207F4291
MPR 13-00318-18
Core clock: 500 MHz, DDR clock: 266 MHz (532 Mhz data rate)
DRAM: 512 MB
Clearing DRAM....... done
Flash: 4 MB
Net: octeth0, octeth1, octeth2
USB: (port 0) scanning bus for devices... 1 USB Devices found
scanning bus for storage devices...
Device 0: Vendor: Prod.: UDinfo UF2 4GB Rev: PMAP
Type: Removable Hard Disk
Capacity: 3824.0 MB = 3.7 GB (7831552 x 512) 0
reading vmlinux.64
.............................
5755008 bytes read
argv[2]: coremask=0x3
argv[3]: root=/dev/sda2
argv[4]: rootdelay=15
argv[5]: rw
argv[6]: rootsqimg=squashfs.img
argv[7]: rootsqwdir=w
argv[8]: mtdparts=phys_mapped_flash:512k(boot0),512k(boot1),64k@1024k(eeprom)
ELF file is 64 bit
Allocating memory for mapped kernel segment, alignment: 0x400000
Allocated memory for ELF segment: addr: 0x400000, size 0x6863d0
Processing PHDR 0
Loading 57ba80 bytes at 400000
Clearing 10a950 bytes at 97ba80
## Loading Linux kernel with entry point: 0x007e5ff0 ...
Bootloader: Done loading app on coremask: 0x3
Linux version 3.10.107-UBNT (root@dc9c2e14f2e4) (gcc version 4.7.0 (Cavium Inc. Version: SDK_BUILD build 51) ) #1 SMP Thu Aug 9 06:45:26 UTC 2018
CVMSEG size: 2 cache lines (256 bytes)
Cavium Inc. SDK-3.1.2
bootconsole [early0] enabled
CPU revision is: 000d0601 (Cavium Octeon+)
Checking for the multiply/shift bug... no.
Checking for the daddiu bug... no.
Determined physical RAM map:
memory: 000000000053b000 @ 0000000000400000 (kernel data and code)
memory: 0000000000045000 @ 000000000093b000 (usable after init)
memory: 0000000000107000 @ 0000000000980000 (kernel data and code)
memory: 0000000007400000 @ 0000000000d00000 (usable)
memory: 0000000007c00000 @ 0000000008300000 (usable)
memory: 000000000fc00000 @ 0000000410300000 (usable)
software IO TLB [mem 0x0170d000-0x0174d000] (0MB) mapped at [800000000170d000-800000000174cfff]
Zone ranges:
DMA32 [mem 0x00400000-0xefffffff]
Normal [mem 0xf0000000-0x41fefffff]
Movable zone start for each node
Early memory node ranges
node 0: [mem 0x00400000-0x00a86fff]
node 0: [mem 0x00d00000-0x080fffff]
node 0: [mem 0x08300000-0x0fefffff]
node 0: [mem 0x410300000-0x41fefffff]
Primary instruction cache 32kB, virtually tagged, 4 way, 64 sets, linesize 128 bytes.
Primary data cache 16kB, 64-way, 2 sets, linesize 128 bytes.
Secondary unified cache 128kB, 8-way, 128 sets, linesize 128 bytes.
PERCPU: Embedded 10 pages/cpu @800000000178a000 s10880 r8192 d21888 u40960
Built 1 zonelists in Zone order, mobility grouping on. Total pages: 125878
Kernel command line: bootoctlinux $loadaddr coremask=0x3 root=/dev/sda2 rootdelay=15 rw rootsqimg=squashfs.img rootsqwdir=w mtdparts=phys_mapped_flash:512k(boot0),512k(boot1),64k@1024k(eeprom) console=ttyS0,115200
PID hash table entries: 2048 (order: 2, 16384 bytes)
Dentry cache hash table entries: 65536 (order: 7, 524288 bytes)
Inode-cache hash table entries: 32768 (order: 6, 262144 bytes)
Memory: 495244k/504084k available (4032k kernel code, 8840k reserved, 1321k data, 276k init, 0k highmem)
Hierarchical RCU implementation.
Additional per-CPU info printed with stalls.
NR_IRQS:511
Calibrating delay loop (skipped) preset value.. 1000.00 BogoMIPS (lpj=5000000)
pid_max: default: 32768 minimum: 501
Security Framework initialized
Mount-cache hash table entries: 256
Checking for the daddi bug... no.
SMP: Booting CPU01 (CoreId 1)...
CPU revision is: 000d0601 (Cavium Octeon+)
Brought up 2 CPUs
NET: Registered protocol family 16
bio: create slab <bio-0> at 0
SCSI subsystem initialized
usbcore: registered new interface driver usbfs
usbcore: registered new interface driver hub
usbcore: registered new device driver usb
Switching to clocksource OCTEON_CVMCOUNT
NET: Registered protocol family 2
TCP established hash table entries: 4096 (order: 4, 65536 bytes)
TCP bind hash table entries: 4096 (order: 4, 65536 bytes)
TCP: Hash tables configured (established 4096 bind 4096)
TCP: reno registered
UDP hash table entries: 256 (order: 1, 8192 bytes)
UDP-Lite hash table entries: 256 (order: 1, 8192 bytes)
NET: Registered protocol family 1
octeon_pci_console: Console not created.
HugeTLB registered 2 MB page size, pre-allocated 0 pages
squashfs: version 4.0 (2009/01/31) Phillip Lougher
Registering unionfs 2.5.13 (for 3.10.34)
aufs 3.10.x-20141215
msgmni has been set to 967
io scheduler noop registered
io scheduler cfq registered (default)
Serial: 8250/16550 driver, 6 ports, IRQ sharing disabled
1180000000800.serial: ttyS0 at MMIO 0x1180000000800 (irq = 34) is a OCTEON
console [ttyS0] enabled, bootconsole disabled
console [ttyS0] enabled, bootconsole disabled
1180000000c00.serial: ttyS1 at MMIO 0x1180000000c00 (irq = 35) is a OCTEON
loop: module loaded
ehci_hcd: USB 2.0 'Enhanced' Host Controller (EHCI) Driver
ohci_hcd: USB 1.1 'Open' Host Controller (OHCI) Driver
OcteonUSB 16f0010000000.usbc: Octeon Host Controller
OcteonUSB 16f0010000000.usbc: new USB bus registered, assigned bus number 1
OcteonUSB 16f0010000000.usbc: irq 56, io mem 0x00000000
hub 1-0:1.0: USB hub found
hub 1-0:1.0: 1 port detected
OcteonUSB: Registered HCD for port 0 on irq 56
usbcore: registered new interface driver usb-storage
octeon_wdt: Initial granularity 5 Sec
TCP: cubic registered
NET: Registered protocol family 17
NET: Registered protocol family 15
Bootbus flash: Setting flash for 4MB flash at 0x1f800000
phys_mapped_flash: Found 1 x16 devices at 0x0 in 8-bit bank. Manufacturer ID 0x0000c2 Chip ID 0x0000a7
Amd/Fujitsu Extended Query Table at 0x0040
Amd/Fujitsu Extended Query version 1.1.
phys_mapped_flash: Swapping erase regions for top-boot CFI table.
number of CFI chips: 1
3 cmdlinepart partitions found on MTD device phys_mapped_flash
Creating 3 MTD partitions on "phys_mapped_flash":
0x000000000000-0x000000080000 : "boot0"
0x000000080000-0x000000100000 : "boot1"
0x000000100000-0x000000110000 : "eeprom"
Waiting 15sec before mounting root device...
usb 1-1: new high-speed USB device number 2 using OcteonUSB
usb-storage 1-1:1.0: USB Mass Storage device detected
scsi0 : usb-storage 1-1:1.0
scsi 0:0:0:0: Direct-Access UDinfo UF2 4GB PMAP PQ: 0 ANSI: 6
sd 0:0:0:0: [sda] 7831552 512-byte logical blocks: (4.00 GB/3.73 GiB)
sd 0:0:0:0: [sda] Write Protect is off
sd 0:0:0:0: [sda] No Caching mode page found
sd 0:0:0:0: [sda] Assuming drive cache: write through
sd 0:0:0:0: [sda] No Caching mode page found
sd 0:0:0:0: [sda] Assuming drive cache: write through
sda: sda1 sda2
sd 0:0:0:0: [sda] No Caching mode page found
sd 0:0:0:0: [sda] Assuming drive cache: write through
sd 0:0:0:0: [sda] Attached SCSI removable disk
kjournald starting. Commit interval 3 seconds
EXT3-fs (sda2): using internal journal
EXT3-fs (sda2): mounted filesystem with journal data mode
VFS: Mounted root (aufs filesystem) on device 0:11.
Freeing unused kernel memory: 276K (ffffffffc053b000 - ffffffffc0580000)
Algorithmics/MIPS FPU Emulator v1.5
INIT: version 2.88 booting
INIT: Entering runlevel: 2
[....] Starting SSH recovery service in the background
ssh-recovery: starting...
ssh-recovery: if=(all) port=(60257) terminate-timeout=(60)
ssh-recovery: enabling link on interfaces...
ssh-recovery: eth0 :: mac=(78:8a:20:7f:42:91)
ssh-recovery: eth1 :: mac=(78:8a:20:7f:42:92)
ssh-recovery: eth2 :: mac=(78:8a:20:7f:42:93)
[ ok ] Starting daemon monitor: monit.
[....] Starting routing daemon: rib nsm ribdssh-recovery: service started :: pid=(663)
. ok
[....] Starting EdgeOS router: migrate rl-systemsync: ignoring all arguments
[ ok igure.
Starting network plug daemon: netplugd.
UNAUTHORIZED USE OF THIS SYSTEM
IS STRICTLY PROHIBITED!
SSHing into the machine
yeri@sg-erl:~$ ping 192.168.1.1 PING 192.168.1.1 (192.168.1.1) 56(84) bytes of data. ^C --- 192.168.1.1 ping statistics --- 3 packets transmitted, 0 received, 100% packet loss, time 2007ms yeri@sg-erl:~$ show vpn ipsec sa IPSec Process NOT Running yeri@sg-erl:~$ configure [edit] yeri@sg-erl# load /config/config.boot Loading configuration from '/config/config.boot'... Load complete. Use 'commit' to make changes active. [edit] yeri@sg-erl# commit [ vpn ] conntrack v0.9.14 (conntrack-tools): connection tracking table has been emptied. [edit] yeri@sg-erl# exit Warning: configuration changes have not been saved. exit yeri@sg-erl:~$ show vpn ipsec sa peer-be.yeri.be-tunnel-1: #1, ESTABLISHED, IKEv1, etc etc etc