Re: Dual WAN pppoe and dhcp

Hi Jordan,

Thank you for looking at this. I tried changing the default route distance but that seemed to result in partial connectivity. 

Output of 'show ip route', public IPs masked

IP Route Table for VRF "default"
S    *> 0.0.0.0/0 [1/0] is directly connected, pppoe0
     *>           [1/0] via X.X.X.1 (recursive is directly connected, eth1) )
C    *> Y.Y.Y.141/32 is directly connected, pppoe0
S    *> X.X.X.1/32 [1/0] is directly connected, eth1
C    *> X.X.X.24/32 is directly connected, eth1
C    *> 127.0.0.0/8 is directly connected, lo
C    *> 192.168.1.0/24 is directly connected, eth2
S    *> 192.168.5.0/24 [1/0] is directly connected, eth1
C    *> Z.Z.Z.5/32 is directly connected, pppoe0

output from ping

ping: sendmsg: Network is unreachable
64 bytes from 8.8.8.8: icmp_req=2 ttl=55 time=15.6 ms
ping: sendmsg: Network is unreachable
64 bytes from 8.8.8.8: icmp_req=4 ttl=55 time=13.7 ms

output from 'show load-balance watchdog' - I don't understand this as the target is clearly reachable via at least one interface as per the ping above.

Group G
  eth1
  status: Waiting on recovery (0/1)
  pings: 3
  fails: 3
  run fails: 3/3
  route drops: 1
  ping gateway: 8.8.8.8 - DOWN
  last route drop   : Fri Dec 23 15:28:43 2016

  pppoe0
  status: Running 
  pings: 12
  fails: 0
  run fails: 0/3
  route drops: 0
  ping gateway: 8.8.8.8 - DOWN