Hey Everyone,
So been working on this configuration for about 3 months, I can't seem to access the VLAN 1 from my "Home" VLAN which is possible on the current configuration that I built this loadbalance config from.
I know I am missing something simple or just gone wrong somewhere but I am the sole person here and the directors want this working asap all help will be greatly appreciated.
I am trying to achieve the following:
WAN1 - VLAN 10+1 - failover to WAN2
WAN2 - VLAN 2+50 - failover to WAN1
The guides/fourm pots i have followed and used so far;
https://community.ubnt.com/t5/EdgeMAX/Ubnt-Edge-Router-Pro-Need-help-with-setup/m-p/768646#M26435
https://community.ubnt.com/t5/EdgeMAX/Prevent-the-Inter-VLAN-routing/m-p/723341
I have attached my config as it’s a bit long to post
Thanks in advance,
Wiz