Re: EdgeRouter X port forwarding not working

Hi there,

Thanks for the quick response. I updated to 1.9.0 as soon as I unboxed the router, and it's been very stable.

I deleted the Ruleset in Firewall, and deleted the Destination NAT rule. I re-established the GUI port forwarding that you specified below (these are the same settings I set up initially, btw). I also tried to create a port forwarding rule where I didn't specify the "Forward-to-port" value, as I read a thread where someone said that might work. No dice. Did you want me to post the config again with the GUI-established port forward?

edit - forgot to specify that my modem is in Bridge mode (Arris TM822G)

edit 2 - here's my new config:

port-forward {                                                                    
    auto-firewall enable                                                          
    hairpin-nat enable                                                            
    lan-interface switch0                                                         
    rule 1 {                                                                      
        description Plex                                                          
        forward-to {                                                              
            address 192.168.1.2                                                   
            port 32400                                                            
        }                                                                         
        original-port 32400                                                       
        protocol tcp_udp                                                          
    }                                                                             
    wan-interface eth0