There should literally be no routing at all. Its all layer 2 traffic. I have two sources of untagged traffic(eth1 and eth2), which I want to tag and then trunk(eth4) out from ERX1 via a wireless bridge, and then ERX2 will take that trunk and then split the traffic again into two separate ports. Ip ranges should not even be considered, as that is layer 3 traffic. All routing is done BEFORE ERX1 from the two uplinks. If you look at my previous post, you can see the configurations I have/desire. To be quite honest, I am using the ERX's more as switches than routers, or so I assume anyway
↧