BranoB wrote:On your picture above, where it says Address from the drop-down select "Use DHCP" and save.
The router should now pull IP from the modem. Modem should be in bridge mode.
Sweet! Now we're getting somewhere. eth0 is now getting a 10.0.0.x IP from the ISP router. Plus I set up DHCP for 10 and 20 as you said to and now a laptop plugged into eth1 is connected to the internet! Progress! OK so tomorrow I'll work on getting the 2nd ERX setup with the two separate vlans and see if I can get everything talking to everything else. Thanks so much!