WAN's keep dropping
Good morning all. We seem to be having an issue with WAN's constantly dropping on one of our EdgeRouter's Any help would be greatly appreciated on this as it's driving us mad!! Every 2 or 3 minutes we...
View ArticleRe: RRAS site-to-site
Hi, sorry for bumping. Is the error I am getting when I use the FQDN related to this?https://community.ubnt.com/t5/EdgeMAX/IPSEC-Site-to-Site-with-FQDN-doesn-t-work-in-1-9/td-p/1644561 If so, can you...
View ArticleRe: ER-X VPN IPSEC stability issue offload related on 1.9.1 firmware
Nobody has any clue regarding this issue? Is it a known issue ?
View ArticleRe: Comcast IPv6 issues when hwnat enabled on ER-X
I don't have a different modem either. If I aquire one I will test however, this one seems to workfine other than that issue. Fb
View ArticleRe: non-load balanced multiwan configuration
Do you have other routers in front of the Egerouter or are you using ppp ? Based on the network topology, configs are a bit different, anyway, you may create a default route for the VLAN 10set...
View ArticleRe: Release: WireGuard for EdgeRouter
here are the results for EdgeOS 1.9.1.1 and WG wireguard-octeon-0.0.20170517-1.deb andreyk@ubuntu:~/.ssh$ iperf3 -c 192.168.1.55Connecting to host 192.168.1.55, port 5201[ 4] local 192.168.15.100 port...
View ArticleEnable PPTP Passthrough
I am trying to connect a windows pc behind an EdgeRouter Lite to a PPTP VPN server at remote location. I can connect to the PPTP VPN from other locations but not behind the EdgeRouter Lite. The client...
View ArticleEnable Parallel Crypto in Kernels
Hello, Please add CONFIG_CRYPTO_PCRYPT=y and CONFIG_PADATA=y to all of your kernels, so that various crypto operations, such as WireGuard, can benefit from the performance boost. The easiest way to...
View ArticleRe: Release: WireGuard for EdgeRouter
Hi Jason, Hardware is the same as all previous tests - 2x EdgeRouter Pro connected via gigabit link.WG is approximately 5 times faster than OpenVPN.
View ArticleRe: pixelserv dnat not working
I thought that too. I ran "ipset list ADS-A" and it returned a lot of IP Addresses. I picked one of those returned for the following testing. Running the recommended command, I got the following......
View ArticleRe: Release: WireGuard for EdgeRouter
Hey , While I'm waiting for UBNT to do something about https://community.ubnt.com/t5/EdgeMAX/Enable-Parallel-Crypto-in-Kernels/m-p/1937956#U1937956 , I decided to compile this code directly into the...
View ArticleRe: DHCP is extremely fragile on ERL
I think this references your issue:https://community.ubnt.com/t5/EdgeMAX/Duplicate-Hostnames-Cause-DHCP-to-Stop/m-p/1671656/highlight/true#M127343 What version are you running, and have you checked the...
View ArticleRe: ER-X VPN IPSEC stability issue offload related on 1.9.1 firmware
I can't personally help, but providing more information might elicit a response from people that are more knowledgeable. Indicate which model of router you're using, as the offload implementations...
View ArticleRe: pixelserv dnat not working
May be obvious, but just checked and I have access-logging on for the pixelserv service (lighttpd)...no traffic seems to get there in these tests. Direct tests against the server (using the internal...
View ArticleRe: How to determine ISP IP lease time
That command works for me, in the latest beta. Make sure you aren't in configure mode when you run the command! j@ubnt:~$ show dhcp client leases interface : eth0 ip address : 65.xx.xx.xx [Active]...
View ArticleIssue where one physical port stops transmitting
I've got a Edgerouter POE 5 and over the past few weeks its been locking up and my whole network dies. I hard restart the device (give it a minute or so between power down and power up) and it comes...
View ArticleRe: How to determine ISP IP lease time
My WAN is setup for pppoe on interface eth1. hank@ER-X-SFP-DSL2:~$ show dhcp client leases hank@ER-X-SFP-DSL2:~$ show dhcp client leases hank@ER-X-SFP-DSL2:~$ show dhcp client leases...
View ArticleRe: Release: WireGuard for EdgeRouter
here is what we have after reloading the deb file and rebooting the router root@R1:/home/ubnt# dmesg|grep wireguardwireguard: WireGuard 0.0.20170517 loaded. See www.wireguard.io for...
View ArticleRe: Unable to delete static route (DUPLICATE/REPOST)
Good morning! Any ideas or solutions that come to mind? I'm happy to test anything. My networking skills are just enough to get myself in trouble so I'm at a loss on how to properly setup static...
View ArticleDual WAN Question
I posted this on Saturday but for some reason it was deleted. My full config is attached. My setup is as follows - ERLite-3 with Eth0 being one DSL line (their modem in front giving DHCP) and Eth1 with...
View Article
More Pages to Explore .....