Re: Bridged VLAN?
Dirty hack.....but most unmanaged switches will pass VLANs fine. All extra VLANs will be present tagged on all ports
View ArticleRe: Link speed to Unifi Switch
Yeah, make sure you're cable doesn't look like this: Had a vendor send me that.... yeah.. in 2017...
View ArticleRe: Link speed to Unifi Switch
toysareforboys wrote:Make sure you have REAL Cat6 cable (full copper, not CCA/aluminum), 23awg or 24awg. -Jamie M.CAT5E will do 1Gbp no problem (if terminated properly).. CAT6 is rated for 10G.
View ArticleRe: Shaper QoS for voice on VLAN
UniGuy wrote:If following this:https://help.ubnt.com/hc/en-us/articles/205198380-EdgeMAX-Quality-of-Service-for-Voice-Over-IP-QoS-for-VoIP-If all voice devices are on VLAN30, would you still use the...
View ArticleRe: Unable to access servers behind ERPOE
dpurgert wrote:Post your config. If it's all on the same network, (191.168.1.x -> 192.168.1.y ), the ER isn't involved at all .. at least not insofar as firewalls. Since you have no firewalls on...
View ArticleRe: Bridged VLAN?
I'm having a little trouble understanding what and why your trying to do this. Is the IPTV box supposed to be connected directly to your provider without an router ????? Why couldn't the IPTV box flow...
View ArticleConfiguring PFSense router behind an EdgeMax Router
Hi, I am new to configuring and using EdgeMax Router. I have successfully connected EdgeMax router to internet through ISP and bridged all the ports with subnet 192.168.1.0/24. All the clients...
View ArticleRe: Configuring PFSense router behind an EdgeMax Router
If the Hosts (PC's) at the 192.168.1.0/24 network (ER LAN) have "internet access" but the Hosts (PC's) at the 192.168.89.0/24 (pfSense LAN) don't have "internet access" seems that you have "something...
View ArticleRe: EdgeMAX EdgeRouter security release frmware v1.9.1.1 has been released!
Upgrade went fine. Router works flawlessly. Only issue is a new display bug for safari 10.1 (11603.1.30.0.34). No information on traffic meters displayed etc. Firefox and chrome the GUI is working fine
View ArticleRe: IPv6 - LAN not getting IPv6 assigned.
I am not exactly sure what your asking, I am not double NAT/Firewall. topology goes Modem ---> Router ---> LAN (Public Gateway)--->Public Edge Router)---> (Private IPv4/Public ipv6)Each LAN...
View ArticleSend local device IP for DNS in Router Advertisements
Right now my ERL is sending Comcast's DNS servers to my lan via router advertisements. I'd like to switch this so that ERL acts as the DNS Server. Is the best way to do this to set this to the link...
View ArticleRe: Simple office & guest setup using ER-X
after another couple of messages from Jonatha, I'm going to post my final port configuration for completeness. We made a small modificaiton to the switch0 config:no ip address, so getting rid of the...
View ArticleRe: Unable to access servers behind ERPOE
Ok, so you are right. This is entirely unrelated to the ERPOE. I should add that the new ERPOE is attached to a Verizon FIOS G110 Router/Modem. Before anyone suggests it, its not possible to put the...
View ArticleRe: Shaper QoS for voice on VLAN
I'm not sure if I can set both. The router in question is in production so I was hoping someone would know off hand.I'll probably stay after hours and try a few things sometime.Thanks
View ArticleRe: Help opening ports in firewall for entire network.
Care to sharw with us your results and solution?
View ArticlePerformance optimization: Order of firewall zones
Hi, I have quite some firewall rules and a gigabit connection to the outside world. The ER3-lite is significantly slower than connecting my laptop directly to the fiber model; I am losing a few 100...
View ArticleRe: Shaper QoS for voice on VLAN
16again, you're saying to set the down policy on all interfaces with LAN access? Right now everything is trunked to a switch so it shouldn't matter in this case, but that's good to know.
View Articletotal block per ip
Hi All been struggling with something for a while now, any chance anyone got any ideas,Using EdgeRouterX-sfp, i want to block all traffic with the exception of facetime and whatsapp.per user ip/mac...
View ArticleRe: Configuring PFSense router behind an EdgeMax Router
Hi, Thanks for replying.Do i need to add any static route in ER Router to PFSense? ThanksDhana
View Article
More Pages to Explore .....