Re: Port Address Translation
Thanks everyone. I haven't had time to test it yet. I'll let you know as soon as I'm done.
View ArticleClik here to view.
Re: UDP packet loss with EdgeRouter Lite
jeremejevs wrote:I can live with not being able to download and upload at 1 Gbit/s at the same time (usually my data goes one way) + assuming you're talking about the IPv6 & HWNAT sticky, my...
View ArticleRe: PBR with VPN to network segment and Firewall zones.
First, on your nat rule 5000, remove the source stanza. Anything going out vtun0 should be masqueraded. There is no reason to filter on VPN_NET. Also, there is no order dependence between nat rule 5000...
View ArticleStrongSwan Plugins DHCP/FARP missing in FW 1.9.1 ?
Hello,it seems to me that strongSwan plugins DHCP and FARP are missing in my FW 1.9.1 on ERL.sudo ipsec versionLinux strongSwan U5.2.2/K3.10.20-UBNT I can't find them in the list shown using:sudo ipsec...
View ArticleRe: Port Address Translation
Makuckn wrote:Jammrock wrote:Doesn't the DNAT only affect inbound traffic? Nope. DNAT stands for Destination NAT. That means the destination will be modified while the source won't be touched. It's...
View ArticleRe: VLAN and switch port
If you need VLANs on switchport, the vlan-aware must be enabled, take a look here as a clue, and here for the firewall rules ...Cheers,jonatha
View ArticleEdgeRouter behind another Router
I am looking to increase network security by placing adding an edgerouter to my home network. I have ATT Uverse which means I have a DSL modem/router/Wifi gateway at the head of my network. My plan...
View ArticleRe: Unable to get PPTP working
Ok, so clearly I have something screwed up in my firewall. I just setup the l2tp vpn on this same router and I can connect just fine to the VPN and I can communicate with the router, but I cannot...
View ArticleClik here to view.
Re: UDP packet loss with EdgeRouter Lite
jeremejevs wrote: However, honestly, ERLite's issue was noticeable only during gaming (barely so), and I don't even game anymore, so I can't say that buying an ER-X was a rational investment. Maybe I...
View ArticleRe: EdgeRouter behind another Router
I have seen Uverse boxes with setting for a DMZ, others allow you to forward all outside traffic to a device (basically the exact same thing without calling it a DMZ). I don't think ATT uses the...
View ArticleHow do I get these 2 talking
Upstream I have several machines on the 192.168.10.x range that are getting there IPs from DHCP. Also connected to this DHCP is my ERX which in turn runs DHCP into two networks 192.168.1.x192.168.2.x...
View ArticleRe: Help, corrupt filesystem on EdgeRouter Pro - Reinstall image needed!
I have ERLs that corrupt every so often (working on adding them to a UPS). I agree, this issue MUST be fixed. Needing to do a graceful shutdown on a router is not good. Not good at all.
View ArticleRe: Trouble getting QoS Shaper to function properly on ER8-Pro
According to manual, ER8-pro is fine for shaping up to 200.....550MB/sTo be on safe side use 200 as max, so it lacks cpu for 300 Moreover, I doubt if your upload QoS is working as intended. It is done...
View ArticleRe: zone firewalls painfully slow
How are you configuring your ZBF? If you are editing the config.boot and rebooting the router, then you may want to look at using the CLI or BUI Config Tree. Using the CLI is actually pretty quick and...
View ArticleRe: How do I get these 2 talking
You need to do a couple things: make sure your ERX is allowing traffic in and make sure that devices on 192.168.10.x know to forward packets destined for 192.168.1.x or 192.168.2.x to your ERX. For the...
View ArticleRe: EdgeRouter behind another Router
Thanks. I just got access to Lynda.com and started a 31hr Network Admin course so I should be able to take it from here.
View ArticleRe: Unable to get PPTP working
Hi ,... I haven't fully read your config, but on a quick look: You have an overlapping IPv4 Range on eth0 and your PPTP/L2TP setup. That's the reason you have a /24 interface route for eth0 in your FIB...
View ArticleRe: Unable to get PPTP or L2TP working
Pptp no longer supported by apple thats why i asked about client machine
View ArticleClik here to view.
Re: PBR with VPN to network segment and Firewall zones.
awesome sauce.. thank you! .i think it was my dhcp scope that was messing me up. fun times.
View ArticleHEADS UP: Site upgrade in-progress, read-only for next ~12 hours
For those who missed the maintenance notice, the migration process of moving the site to a new forum platform is in-progress and the site is read-only until that is completed. Rough ETA on completion...
View Article
