I want to send 3 WANs from one location to another then disperse them between customers evenly. This is how my setup will work and I'm wondering if I need to change anything and would really appreciate help. Each WAN has a 100Mbps down and a 40Mbps up.I can post a diagram later if anyone is confused, here goes.
WAN 1,2, and 3 all going into EdgeRouter X or toughswitch POE through eth0 (VLAN10) eth1 (VLAN20) and eth2 (VLAN30) , eth4 (VLAN10,20,30) then goes out to and AirFiber 5X which goes to another AirFiber 5X which plugs into eth0 (VLAN10,20,30) on a 16 port EdgeSwitch 150w. eth1 eth2 eth3 and eth4 are all assigned to VLAN10 then plug into 4 PowerBeam ACs ISO, these go to 4 more PowerBeams. eth5 eth6 eth7 and eth8 are all assigned to VLAN20, all going through PowerBeams to more PowerBeams. eth 9 eth10 and eth11 are all doing the same thing as eth1-eth8 except they're on VLAN30. eth12 will be my management port as well as providing VLAN 30 internet.
Some of the big questions I have is do I need to apply the VLAN to every single port that the connection runs through, or just on the edgerouter and edgeswitch? Also should I turn my PowerBeams at the customers house into a router instead of a bridge. Will all the hardware be able to keep up? And will all the customers get even distribution of bandwidth when the system is fully underload?
All help is greatly appreciated as I am new to this kind of stuff.