Hello,
I'm quite new with network confirguration, so my question might be really "dummy".
I'm building simple home network which consists of
- EdgeMax ERPoE 5
- Several access points PicoStation M2HP (connected to router via cable)
To begin with I've connected one access point to the router and used following manual for configuration https://help.ubnt.com/hc/en-us/articles/205197660-EdgeMAX-SOHO-Example
I used exact IPs as in the example. After configuration everything worked fine (LAN/WAN) and I continued to 2nd step to extend network coverage in other part of the house and connected 2nd AP to ETH3 port via cable.
So basically I'd like to have following topology:
Image may be NSFW.
Clik here to view.
2nd AP itself, I've configured exactly the same as first (SSID, Security, Bridged mode, the only thing, that I setup unique IP address).
The question is, what router configurtion changes need to be made to make 2nd access point working? How ETH3 port should be configured and may be there are other changes required.
I would really appreciate any help.
