Hey Jordan,
Pardon the delay. Just to make sure I'm understanding and explaining myself well:
* Switch0 carries VLAN 6, 7 and 69 on eth4 which is connected to my AP.
* My switch0 says it has designated 192.168.2.x as its range, and while it's not specified in the VLAN config on port 4, I have SSID "elliot" setup (without VLAN specificiation) that works great and hands out 192.168.2.x addresses to wireless clients.
Screenshots:
* evilcorp - showing an example - that VLAN 69 is specified for this SSID
* elliot - showing no VLAN is specified but wireless clients on that SSID (elliot) receive 192.168.2.x addresses
* switch0 - showing that 192.168.2.x is the range managed by this switch
* switch0-vlan - shows that port 4 hands out VLAN 6, 7 and 69
Questions/TL;DR:
* With this config, none of the VLANs can talk to one another - is this expected behavior? By everything else I'm reading, it seems like they should. Note: I don't want them to talk to one another, but just want to make sure my config is tight/right.
Thanks,
Brian
