For compex ISP reasons, I want to setup one Edgerouter X to replace two ISP routers (each with MAC-address-based Static IP allocated from the same ISP) with VoIP functions.
I need to set the MAC addresses for the old routers at Eth0 and Eth4 (which I know how to do from the command line using config) and then set Eth0 as WAN1 connected to Eth1 as the LAN side plus Eth4 as WAN2 connected to Eth3 as the LAN side. Eth1 and Eth3 will be on different subnets. I see how to use the Wizard to set two WAN ports but I cannot see how to then tie LAN Eth1 (with subnet IP 192.68.7.1/24) to WAN1, and LAN Eth3 (with subnet 192.168.2.1/24) to WAN2. Eth3 will be off. Can this be done from the CL on the EdgeRouter X? If it canm would somebody who knows how to do this point me to some useful Ubiqiti documents or even post the CL code to achieve what I need (forever in your debt).
I am running Firmware 1.90.
There is no need for Fail Over between WAN1 and WAN2.
Thanks.