Hello. I am having the same problem. I am using Windows 10 and I have Verizon Fios as my ISP. I first connected eth0 to my computer Ethernet port and set my computer IP to 192.168.1.4. I was able to connect to the router at 192.168.1.1. Since I had previously downloaded the newest firmware, before I changed any settings I uploaded v1.8.5 firmware. I thought there might have been a problem upgrading because the router wouldn't initially reconnect after reboot after the installation, but when I refreshed my browser, it connected. I then used the WAN+2LAN2 wizard and kept eth0 as DHCP, used only 1 LAN, and left the LAN1,2,3,4 with the already filled in IP 192.168.1.1. I also changed my username and password for the router. I applied the settings and then rebooted the router and changed the connections so that eth0 was connected to my modem, eth1 to my computer, then switched my computer Ethernet adapter to automatically obtain IP settings, but now was no longer able to connect to the router or the Internet. The Windows 10 troubleshooter kept saying the DHCP was not enabled, even though the adapter settings window showed that it was and also kept saying the Default Gatway was not available.
Please let me know if I'm doing something wrong or if there is a specific order to the steps of software configuration and hardware installation or if there's a setting that needs to be switched.
Thanks so much!!
Please let me know if I'm doing something wrong or if there is a specific order to the steps of software configuration and hardware installation or if there's a setting that needs to be switched.
Thanks so much!!
